If a private well stops delivering, the cause is often the pump, the pressure tank, the pressure switch or a power problem, and a plumber can tell which in one visit. Homes that connect to a public utility do not need this service. Call the number on this page to be connected with a local plumber in Largo.

What owners usually notice
- No water at any tap
- Pressure that fades during a shower
- A pump that clicks on and off every few seconds
- Air or spurts coming from faucets
- Sand, silt or a new odor in the water
- A higher electric bill than usual
A property showing two or three of these is worth a call before the pump burns out.
A high water table, but not a guarantee
In many areas the water table is shallow, which helps wells, yet seasonal drops can lower the level a pump draws from. A dry spring followed by heavy use can leave a pump pulling air. Conditions vary property by property, so a plumber reads the pump's behavior over several days rather than guessing from one dry afternoon.
Hardness of about 217 ppm on average (roughly 11 to 14 grains per gallon) is reported for the public system, and private wells nearby may run higher, so scale on pressure switches and fixtures is worth watching.
Because many homes in this area date to the 1970s, well equipment is often old and may need tank, switch and wiring updates along with the pump.
Planning around a warranty
Ask whether a new pump, switch or tank carries a manufacturer warranty and whether the plumber's labor is covered if the same part fails again. Keep the paperwork with the well records. Written model numbers also help the next plumber match parts, which keeps later visits shorter and the quote closer to the first estimate.
Questions worth asking
- Which part failed, and can I see it?
- Was the tank tested, or only the pump?
- What pressure range is the switch set to now?
- Is a follow-up visit included if sand or air appears?
Clear answers to these four are a good sign that the plumber knows wells.
Before hurricane season
Fill clean containers with drinking water, know where the pump breaker is and consider how you would run the well if power fails. After a storm passes, check for flooding around the well head, since floodwater can contaminate the supply. Flooded wells often need testing before the water is used again. Keep drinking water on hand until the well is confirmed safe.
Know your providers in Largo
Pinellas County Utilities supplies water to most Largo addresses; wastewater goes to Largo Sewer. Providers can differ by address, so your bill is the final word.
A break on the utility's side of the meter, or water bubbling up in the street, goes to Pinellas County Utilities at (727) 464-4000.
For a gas odor in Largo, get everyone out, then call 911 and Peoples Gas at 877-832-6747 from a safe distance.
Permitted work in Largo, such as a water heater swap or new gas piping, is filed with the City of Largo Building Division.
Calls from Largo are often matched with plumbers who also work in Belleair Beach, Indian Rocks Beach and Seminole.
Well Pump Repair questions in Largo
Why is well water sandy or cloudy near Largo?
Does hard water hurt a well pump?
Should a well pump be replaced along with the tank?
Can I run a generator on my well pump?
More plumbing services in Largo
Well Pump Repair nearby
Helpful guides
Sources
Last updated: